Use a utility knife to trace the outline of the latch onto the frame. Aligning the Strike Plate Even after adjusting the hinges, the door might still fail to latch if the strike plate is not aligned with the latch.
DIY Sagging Door Hinge Repair: Realigning the Strike Plate
This guide will walk you through the precise steps to identify why your door is sagging and how to restore a tight, secure seal. Humidity and temperature fluctuations can also cause the wood to expand or contract, changing the fit between the door and the frame.
Remove the strike plate and use a chisel or a sharp knife to carefully widen the hole to match the latch. Start by loosening the screws on the hinge plates, both on the door and the frame, without removing them completely.
DIY Sagging Door Hinge Repair: Aligning the Strike Plate
To fix this, close the door and observe where the latch hits the strike plate. If the door is sagging, move the bottom hinge slightly downward or the top hinge slightly upward, then gently tap the door into place before tightening the screws.
More About How to fix a sagging door that won't latch
Looking at How to fix a sagging door that won't latch from another angle can help expand the discussion and give readers a second clear paragraph under the same section.
More perspective on How to fix a sagging door that won't latch can make the topic easier to follow by connecting earlier points with a few simple takeaways.
