At this stage, you can gently lift the circuit board out of the lower housing to inspect the transformer or to replace a blown fuse, but avoid pulling on the individual wires. Use your spudger to gently pry these tabs apart, starting from the seam where the two halves meet.
Complete Visual Guide to Xbox 360 Power Supply Teardown
If you are dealing with an Xbox One or Xbox Series X, the plugs are completely different, and this specific guide does not apply. You will also need a spudger or a small flat pry tool to gently separate the plastic clips without cracking the casing.
Identifying Your Power Supply Unit Before you begin the teardown, you must confirm you are working with the correct device. Look for any cracks or breaks where the wires connect to the board, as this is a common failure point due to the heat generated by the power supply.
Xbox 360 Power Supply Teardown Complete Visual Guide
Look for the model number "APM-06" or "APM-12" printed on the underside; this ensures you have the slim version that matches the teardown steps outlined here. Before touching any component, verify that the unit is disconnected from power.
More About Xbox 360 power supply teardown
Looking at Xbox 360 power supply teardown from another angle can help expand the discussion and give readers a second clear paragraph under the same section.
More perspective on Xbox 360 power supply teardown can make the topic easier to follow by connecting earlier points with a few simple takeaways.
